b16 wont rev and runs bad
Posted 04-08-2009 at 06:01 PM by civic2188
i have an obd1 b16 in my 97 ek hatch. i did the swap a couple years ago and it never did idle right and i had to sometimes reset the ecu. but here lately ive come into a huge problem. the engine wont rev over 3k and when i do hit the throttle it really dies out and then i let off and it jumps to 3k before comin back down. but if i hold the throttle wide open it revs to 3k and bogs way out and will start to backfire. i have checked the entire fuel system and even put a new distributor on the car but nothing has helped. if anyone has any idea whats happening please let me know. THANKS
Total Comments 3
Comments
|
|
give me a call 1-785-241-6715 i htink i could help you on this problem bcuz ihad the same problem with my swap
|
Posted 04-11-2009 at 03:31 PM by 97h22dxcoupe
|
|
|
check your compression and see if you have a bad ecu or if not that then get a used or new wiring harness that should help or at least fix it due to your lack of compression and see if any trouble codes come up when u bring it to shucks ask them to do a DTC's check and write it down and hit me up when you can so i can help you with your problem
|
Posted 04-21-2009 at 11:26 PM by 91preludejdmized
|
|
|
I have the same problem and it was the ring on the screw of the fuel rail, that ring must be over and not under the screw. The presure should be over 35. Other reason could be the fuel pump, replace it.
|
Posted 04-22-2009 at 05:15 PM by alex_sotam
|
Total Trackbacks 0
Trackbacks
Recent Blog Entries by civic2188
- b16 wont rev and runs bad (04-08-2009)




