h22 swap ?'s
Posted 11-16-2008 at 04:35 PM by ejcoupe
i have a 97 civic coupe with the D16Y8. i want to do a H series swap H22 preferably. what am i getting in to? my car is completly stock with 2.25 piping from the cat back.what do i need for the swap??? i am about to order coilovers but curious what ones to get to support the motor. and do i need the all round disk breaks from the 2000 si???
Total Comments 3
Comments
|
dont lower the car untill u put the motor in first the oil pan hangs low. i have a 96 coupe with an h22a1 i got hasbro motor mounts and a computer off a 96 prelude with a crome program for controling the amount of air flow your going to be pushing i have a 3in straight pipe w/obx exghust and act/clutch/flywheel/plate. i have ground control coilovers get good shocks and u will be fine good motor i run 12.2s w/it and a crower stroker kit a 2.4L converstion.any more questions let me know later
|
 
|
|
|
and i run my car with powerslot rotors in the front but the si convertion is good stoping power
|
|
|
|
|
first of all be aware cause when you'll have this engine into it your car will be way heavier and the curves harder but you'll have a lot of fun on strait lines
|
|
|
Total Trackbacks 0
Trackbacks
Recent Blog Entries by ejcoupe
- h22 swap ?'s (11-16-2008)
