A Honda & Acura Forum and technical discussion board. Topics include hybrid and swap information, turbo installation, tuning, ecu chipping, jdm parts and accessories, suspension setups and much more. Join us at HondaSwap.com
This is a discussion on 1/4 mile speed CRX w/zc in the Engine Building forum
I'm putting in a zc motor into my `91 crx dx, basic setup, integra ecu, 2.25" exauhst, intake, better cams, 88 crx si tranny. Another question if anyone knows, put my new clutch on and put transmission on. I decided to test it out by ...
| || |
| || ||LinkBack||Thread Tools|
|02-07-2004, 03:00 PM||#1|
I'm putting in a zc motor into my `91 crx dx, basic setup, integra ecu, 2.25" exauhst, intake, better cams, 88 crx si tranny. Another question if anyone knows, put my new clutch on and put transmission on. I decided to test it out by spinning crank and pulling up on clutch lever, axels still move! There isn't alot of resistence there either. Everything lined up ok and I'm sure its the right clutch and flywheel.
|02-14-2004, 02:33 PM||#4|
Thanks, I am the only one around I know of that has this motor, so its nice to know someone who can give you "rough" speed estimates. Anyone know the answer to my other problem?
|02-15-2004, 10:37 AM||#6|
This topic has been closed
Why? It is in the wrong place. Please post your topic in the right forums. Hybrid is not for suspension or interior posts. EG is not for EF questions, and so forth.
If you have any questions, please PM the moderator who closed this topic.
-The moderating Team
|Thread||Thread Starter||Forum||Replies||Last Post|
|FS: 92 Integra 5 speed tranny/block/sunroof/ more!||91Integracer||Parts: For Sale/Trade/Wanted||9||04-09-2004 05:35 AM|
|RSX S, GSR, Type R, CL-S||Sergey P.A.||Members' Lounge||10||01-31-2004 03:42 PM|
|my motor's top speed is 120 MPH||Teambypass||HYBRID -> EG-EK / DC||7||10-16-2003 06:01 PM|
|Sir speed sensor||wisemansoji||ECU's, Electronics, and Tuning||5||07-01-2003 02:29 AM|
|Top Speed Limiters||tightnunphazed||Engine Building||6||06-20-2003 03:18 PM|