http://hondaswap.com/ en Thu, 09 Sep 2010 12:02:01 GMT vBulletin 60 http://hondaswap.com/images/misc/rss.jpg http://hondaswap.com/ http://hondaswap.com/ecus-electronics-tuning/need-help-after-engine-swap-ecu-help-506876/ Wed, 08 Sep 2010 06:26:10 GMT Due to reasons beyond my control I had to get a new engine, it runs ok enough however the ECU thats on it is not the right one so minor conversion... Due to reasons beyond my control I had to get a new engine, it runs ok enough however the ECU thats on it is not the right one so minor conversion had to be done. I have a 98 civic sedan AT that had a D15 non v-tec engine and now it's a D15B v-tec. Now I did some research, the ecu that normally comes with a D15 is a P28 and what I need for the D15B is a P2j. Now if I get the new ecu I know i'll need a corresponding wire looms, now how the hell will the connections go? Also It has come to my understanding that even after doing a mirracle ecu installation my car still will fall short of expectations bcuz the ecu is a bit lazy on the v-tech so i'd need a v-tec controller compatible with a 3 stage v-tec system.
NEED HELP REAL BAD:eek::eek::eek: ]]> crosses http://hondaswap.com/ecus-electronics-tuning/need-help-after-engine-swap-ecu-help-506876/ http://hondaswap.com/ecus-electronics-tuning/rewire-my-car-shoddy-wiring-506386/ Wed, 08 Sep 2010 01:58:13 GMT Get 'em both. I can't remember where exactly I got mine but there all available free for download onda net if you look hard enuff. Information is power!! ]]> B18C EG6 http://hondaswap.com/ecus-electronics-tuning/rewire-my-car-shoddy-wiring-506386/ http://hondaswap.com/ecus-electronics-tuning/91-civic-code-4-dohc-zc-506560/ Tue, 07 Sep 2010 15:27:25 GMT Good luck with correcting the shit work done by the old owner. It will be worth it when you get it going right though. Good luck with correcting the shit work done by the old owner. It will be worth it when you get it going right though. ]]> Fernpatch http://hondaswap.com/ecus-electronics-tuning/91-civic-code-4-dohc-zc-506560/ http://hondaswap.com/ecus-electronics-tuning/b18a1-into-crx-505918/ Thu, 02 Sep 2010 22:03:23 GMT well its off the fire wall it wont even turn ignition is a no go so im working on it today well its off the fire wall it wont even turn ignition is a no go so im working on it today ]]> saulrod65 http://hondaswap.com/ecus-electronics-tuning/b18a1-into-crx-505918/ http://hondaswap.com/ecus-electronics-tuning/msd-ignation-kit-506450/ Wed, 01 Sep 2010 03:43:21 GMT www.msdignation.com...]]> hi...any body know where to find msd ignation kit for h22a i search on www.msdignation.com didn't find for h22a or the kit any one help i also saw v6 v6la i didn't know msd ignation have types also i need details for this and wich one is most powerfull one >>and who know where to find the kit pleas put the link straight up for the h22a thank u:) ]]> cant get enough http://hondaswap.com/ecus-electronics-tuning/msd-ignation-kit-506450/ http://hondaswap.com/ecus-electronics-tuning/lol-1997-crv-b16-auto-wtf-ecu-506409/ Tue, 31 Aug 2010 22:54:59 GMT C'mon guys, I evaluated that before this took place. I'll drop a little more detail though.
My gf drove the b20 overheating, until it was burning water at a rapid rate. Upon inspection of the thermostat housing/water inlet pipe, I'm 80% sure the water jackets are fucked. This eliminated me replacing the HG.

Compression was 150, 155, 100, 135. I had a theory, with those numbers, I wasn't putting much down to the wheels anyway. Especially with it burning water in #3.

Surprisingly, the B16 doesn't feel any different so far. But, I'm not making much use of the b16 powerband. If the b20 had 130lb tq new, I'm gonna guess the condition of my b20 was probably equal or less than the 110lb the b16 provides. This is an assumption but I can't tell a difference in power in the low end. I can feel a mid-range 'lack' or torque. Near 3.5k rpm, where the b20 is maxing out tq, the b16 is getting ready for VTECHHHH.

If I get an auto-p28, does that control the 4wd? Is there a different tcm for the 4wd? ]]> VTECin5th http://hondaswap.com/ecus-electronics-tuning/lol-1997-crv-b16-auto-wtf-ecu-506409/ http://hondaswap.com/ecus-electronics-tuning/fuse-problem-help-505503/ Sat, 28 Aug 2010 02:36:50 GMT Maybe a relay?:confused: Maybe a relay?:confused: ]]> Genamel12 http://hondaswap.com/ecus-electronics-tuning/fuse-problem-help-505503/ http://hondaswap.com/ecus-electronics-tuning/94-civic-ex-506174/ Sat, 28 Aug 2010 02:32:50 GMT Im a noob and dont know much about kill switches. Ive read other post and done research about kill switches. I need help on what wires to splice or... Im a noob and dont know much about kill switches. Ive read other post and done research about kill switches.
I need help on what wires to splice or an ignition wiring diagram. Also do i need a 24 awg wire or will it just start a fire in my dash? ]]> Genamel12 http://hondaswap.com/ecus-electronics-tuning/94-civic-ex-506174/ http://hondaswap.com/ecus-electronics-tuning/holley-500-carb-b20-505813/ Mon, 23 Aug 2010 17:50:18 GMT Dizzy set up With Carbs - onecamonly.com There's...]]> Dizzy set up With Carbs - onecamonly.com

There's also budget standalones: Megasquirt/Mega Jolt, etc. ]]> K2e2vin http://hondaswap.com/ecus-electronics-tuning/holley-500-carb-b20-505813/ http://hondaswap.com/ecus-electronics-tuning/how-hot-wire-96-integra-41851/ Mon, 23 Aug 2010 01:57:45 GMT Do I need to cut some of the ignition wires? or does my car have an anti-theft system? Also there are two little wires that are attached to this... Do I need to cut some of the ignition wires? or does my car have an anti-theft system?
Also there are two little wires that are attached to this little devices that hangs right under the ignition key. There is also like a little pad thing under with two switches and a little button. one switch says beeb on and beeb off, the other switch says normal and disarm valet and the button is just a black button.. PLEASE HELP ]]> alkhalil http://hondaswap.com/ecus-electronics-tuning/how-hot-wire-96-integra-41851/ http://hondaswap.com/ecus-electronics-tuning/b16-block-b18-head-505650/ Mon, 23 Aug 2010 01:34:48 GMT yeah. you shouldnt have a problem with the harness. yeah. you shouldnt have a problem with the harness. ]]> invisibledemon http://hondaswap.com/ecus-electronics-tuning/b16-block-b18-head-505650/ http://hondaswap.com/ecus-electronics-tuning/anybody-know-how-upload-software-dynameter-505534/ Sat, 21 Aug 2010 20:26:17 GMT will do thank ya sir :thumbsup: will do thank ya sir :thumbsup: ]]> EF9_boy http://hondaswap.com/ecus-electronics-tuning/anybody-know-how-upload-software-dynameter-505534/ http://hondaswap.com/ecus-electronics-tuning/bad-ground-505388/ Thu, 19 Aug 2010 12:35:56 GMT The Car Pretty Much Shuts Down once the Temp Gauge hits H. The car is not over heating but i guess the ECU reads it as Such I am Thinking about... The Car Pretty Much Shuts Down once the Temp Gauge hits H.
The car is not over heating but i guess the ECU reads it as Such

I am Thinking about taking it to A Local Installation shop & Having them install a VAIC
Butt typically i am not a big fan of those ]]> daGSRhatchNEPA http://hondaswap.com/ecus-electronics-tuning/bad-ground-505388/ http://hondaswap.com/ecus-electronics-tuning/haveing-probs-rpm-gauge-504868/ Tue, 17 Aug 2010 18:44:50 GMT yea thats all the things i changed to obd1 , i mean it works but just sometimes like ill be driveing and ill trun my lights on and the rpm will just... yea thats all the things i changed to obd1 , i mean it works but just sometimes like ill be driveing and ill trun my lights on and the rpm will just shut off but then ill flick my lights off it will come back on but no matter what it never works past 5500 and thats when vtec hits ]]> scottybyo http://hondaswap.com/ecus-electronics-tuning/haveing-probs-rpm-gauge-504868/ http://hondaswap.com/ecus-electronics-tuning/input-codes-need-direction-501323/ Tue, 17 Aug 2010 07:17:15 GMT There is NO such code. The so-called "code" was PROVEN fake a long time ago. The only thing it does is take you to the menu that shows you the software version and network info. That's it. If there was a way to get free minutes or direct connect, Boost Mobile would be out of busines



electronic gadgets-buy electronics
Car Diagnostic Tools-CarECU ]]> Razorback64 http://hondaswap.com/ecus-electronics-tuning/input-codes-need-direction-501323/