does anyone know of any spray that would be good to use to prevent heavy wet snow from clogging the chute on a snowblower?
maybe ski wax like we used to use on the metal shovels?
maybe ski wax like we used to use on the metal shovels?
Snowblowers vs wet snow
- Thread starter reckedracing
- Start date
- Replies 15
- Views 626
We may earn a small commission from affiliate links and paid advertisements. Terms
i've never really had an issue with that here in Wisconsin. I am assuming you have the belts tightened and you are slowing down - correct?
the belt is actually a little too small so it never disengages, just put the new belt on this morning
that was my first idea
and i'm only running it in 1st gear, so thats as slow as it goes.
the last few storms we've had here in NY have been snow followed by mist and rain, so its making a heavy wet mess
I guess my next move would be to clean the carb because its having to run at half or 3/4 choke, so maybe its just not having the power to throw the slop out of the chute
that was my first idea
and i'm only running it in 1st gear, so thats as slow as it goes.
the last few storms we've had here in NY have been snow followed by mist and rain, so its making a heavy wet mess
I guess my next move would be to clean the carb because its having to run at half or 3/4 choke, so maybe its just not having the power to throw the slop out of the chute
You could also try silicone spray.....
this is a 2 stage snow throw
toro 8hp 22 or 24"
its a pretty decent sized snowblower, its just the real wet nasty shit once it gets above freezing and starts raining and getting real wet.
toro 8hp 22 or 24"
its a pretty decent sized snowblower, its just the real wet nasty shit once it gets above freezing and starts raining and getting real wet.
What's a snowblower?
Definitely get the engine 100%. Drain the carb bowl, then check for fuel flow to the bowl. Fresh gas going through will help. Dirty fuel or a motor that has sat for a long time, those are good reasons to clean the carb. Small engine carbs are so simple, problems are easy to figure out/fix. If the float is ok, the main jets needs to be clean, and you're set.
Don't use silicone spray. Don't use cooking spray.
Use Ski wax, skateboarding wax, hard paraffin, or turtle wax on the entire interior of the blower, including the blades, chute, and any surfaces that receive the snow spray.
Tab has some good suggestions too, make sure the engine is running right. I'd personally take it out on a warm day and run it just to blow away all that carbon and crud in the carb. Get it good and hot. and make the belts are correct, then let it cool down, and check the belts again.
I thought most snow blowers were chain drive... I guess not.
Use Ski wax, skateboarding wax, hard paraffin, or turtle wax on the entire interior of the blower, including the blades, chute, and any surfaces that receive the snow spray.
Tab has some good suggestions too, make sure the engine is running right. I'd personally take it out on a warm day and run it just to blow away all that carbon and crud in the carb. Get it good and hot. and make the belts are correct, then let it cool down, and check the belts again.
I thought most snow blowers were chain drive... I guess not.
Yeah. Someone said that their shop was going to put in an order.