Need Some Facts for my EK swap

[Pishpeng]

Heres the plan.

1994 integra LS swap into my 1997 Civic hatch.

What i Know. I need SI mounts, any b series shift linkage + axles.

Since the LS is OBD1 and my car is OBD2 i will also need a jumper harness.

Heres my main concern. I have to swap my ek harness onto the ls motor correct? will i have to cut anything or extend any wires? all the swaps i have done in the past were all obd1 to obd1 or obd2 to obd2. and will all the senors plugs match up?

And one more thing....what is a 94 ls motor OBD1a or OBD1b??

Sorry if this is in the wrong section im kinda new to the site thanks for the help.

 

[Pishpeng]

anyone out there?

 

[Shock_whore]

can't help you with the other questions... but i'm sure the 94 ls motor is obd1 P74..ECU Identification - Team Integra

 

[Shock_whore]

ECU Identification - Team Integra

 

[eg6sir]

can't help you with the other questions... but i'm sure the 94 ls motor is obd1 P74..ECU Identification - Team Integra

did he not state that it was obd1 in the first post..

yes, you'll need a obd2-obd1 conversion harness.

there is no obd1a or obd1b.. its just obd1

 

[invisibledemon]

you seem to have everything. you may need to extend some wires and you may have a sensor or two left over. nothing big, if its not on the engine then you dont have to worry about it.