Recent content by 92hatchF22a

i have got a wicked idea! i havent seen it done yet, but there is a lot of pepole out there so who knows. ok ill cut to the chase. i am going to put a s2000 front end(bumber, lights, fenders, etc.) on my shaved 92 hatch. (trunk included) ill probley have to have the hoods spliced. but i dont...

i had a 255 n a del sol and the line pressure was rediculus. mianly the return line but it did promote problems. i wouldn't recomend it for n/a motors. i speak only from trying it. what happened was that basicaly to much pressure. caseing damage to lines and running statis wasnt the best. hard...

cam for sure.

also if you plan on ditching the motor pm me i want the head. thanks.

depends on what went wrong with the motor buddy. if you just spun a rod bearing then i would sent it to a shop and have the bearings replaced. new water pump, timing belt, gasket kit, and have the head tighting up. ( check for vavle lash) and u should get a nother 100k out of it on a daily...

get ur shipping box dimensions and weight and tell me what it would cost to ship to 12921 please. if its under 700 ill take um> pm me thanks

no one is waning to part wit a stock motor?

i also need the map sensor if you still got it thanks.

i had put an f22a1 accord motor in my 92 hatch. but never fully got her running in tip top shape. i was wondering if anyone who is swaping motors if there stock one runs well and wants to get ridof it i am down. i would like a d16y6 or z6. but would settle for a d15. ill go back to the d seires...

house rules! and finally thanks! does this bolt rite up? do i need to swap any sensors or what?

reallly nobody has swaped thottle bodys on an accord.

a few problems here and there but this computer sucks so i dont think its the site

you also could have the dirsbuter in the wrong location. which would cause you to advance or retard your timming causeing you problems. i have see this problem more then once after a new distrubuter was installed. check it out.

why sell the steering wheel when i will buy the car. whould you sell it?

no body has got an old accord lying around. or if some one could locate one? i have been told i need to do this by hand can any one get me a pin out for the f22a1 and the d15b8. so i can do the wiring by hand?