Recent content by All Show

  1. A

    D-Series Project

    Thanks a lot, I could have figured out some of that stuff by trail and error but when I go to do a job I like to know what I am getting into and what problem I may have. Thanks again.
  2. A

    D-Series Project

    Someone out there must know, I don't think this is cutting edges stuff. A little help please. Thanks
  3. A

    D-Series Project

    Bump
  4. A

    mini me compression problems?

    Those numbers don't seen right to me but to check you can go to this site. http://www.knology.net/~jediklc/D.htm
  5. A

    D-Series Project

    bump
  6. A

    D-Series Project

    I would like to use the Y8 head and IM because they flow better. If I decide to use the the Y8 head will in need a Y8 distrubitor or will the Z6 or Y7 distrubitor work? Will the Z6 engine harness plug into my body harness? When buying head bolts do I match the head bolts to the head? Can I...
  7. A

    D-Series Project

    I have a 99 DX and just bought a Z6 engine complete with tranny, header, IM, distrubiter, ECU and engine harness. I also have a Y8 head and IM. This is what I was thinking of doing but not sure if it will work. Use the Y7 block, Y8 head, Y8 IM, Y7 TB, Z6 tranny, Z6 header, and the Z6 ECU...
  8. A

    junkyards

    You might be able to find out by going to www.car-part.com It is a site consisting of junkyard parts from hundreds of junkyard accrost north america. I think you can search state by state too.
  9. A

    Z6 into a OBD2B

    Anybody?
  10. A

    Z6 into a OBD2B

    What is the problem with the crank sensor? I decided to use the Y7 harness because I had read some where that I could not use the Z6 harness because the the Z6 harness plugs into the chase harness that the chase harness plugs into the ECU. This may not be true but is something that I have...
  11. A

    Z6 into a OBD2B

    I want to install a Z6 motor and tranny into my 99 DX and was wondering what sort of problem I may have with this. Yes yes I know that I could do a mini me swap but it is way too expencive. By the time I buy a knock sensor, tranny, IM, head, solenoid, a P2P ecu and a upper engine gasket kit I am...
  12. A

    Does the Z6 have a 2 or 3 wire IAC?

    Does the Z6 use the 2 or 3 wire IAC valve? Will the 3 wire IAC bolt up to a manifold/TB that normally would have a 2 wire one? Why does Honda use 2 wire sometime and 3 wire the times?
  13. A

    z6 Vs. y8 Vs. y7

    Is that true? I have never heard of this before. If this is true could someone explain to me why longer gear are better in a turbo set up that shorter gears.
  14. A

    d16y7 im to y8 im

    The best thing to do is use the Y7 TB and swap the TB mounting plate from the Y8 TB to the Y7 TB. Or you can run you throttle cable under you IM and build custom TB cable bracket. I did the second of the two because I didn't have the Y8 TB and I couldn't just buy the plate from Honda, they...
  15. A

    d16z6 vtec valve cover on a d16y8

    Yes
See more
Back
Top