Recent content by krash33

what can i do? my car was out of time and i adjusted the timing TDC before intake to set it back to hoe it was suppsed to be but now it is acting like its rinning on 3 cyl..

ya but have no clue about them nor the funds for one.. that would decking the head work to try to get like 13:1 compression.. iknow port n polish will help and pistons with shorter skirts and cams and things of that nature and the port n polish will be done by me. i have worked in a race shop...

what will have to be done to make 260 to 300?

how much hp do you get from a properly built ls vtec ?

what is in the ls vtec kit?

hey best thing to do is call the dealer or a good import mechanic and talk to them it might have depending on how close your valves are to the piston..

for the hell of it spray alittle starting fluid in the intake and crank it and see if it starts.. and ckean and tighten all grounds

what gsr head will i need to fit? do i have to use a 90 or can i use newer

Ok thanks for all the help

So basically arp fasteners new bearings...what else would be needed?? Any help will be greatly appriciated

Look in the junk yard u may get lucky and get one that needs thinks like the intake which u already have..but personally if If ur mechanicaly inclined replace the vacuume lines and clean everything with carb cleaner and see what happens...good luck

To to the has head will I have to do a block girdle and a new ecu to run the new head the biggest fear is blowing the bottom end because I'm going to do a full on port n polish on the head and port match the intake and excuse ports

my buddy has a 90 integra with a b18a1 and his motor was supposed to be freshly rebuilt with about 10,000mi but he is haveing high milage problems

let me know if that was it.. and how many miles does it have?

hey i was looking in some sites they say the ignition control moduel or coil.. and i talked to a friend and his did the same thing yours is and we replaced the col and it runs now u should be able to take and have them tested at the parts house and make sure you have good grounds