Recent content by sniezek66

I just did a swap in my 90 accord and what i did was used the p/c bracket that came with my original f22 accord motor and used my orignal p/s pump. What you do have to do is cut a piece of metal tubing or use nuts to shim behind the hole on the bracket. The reason for that is there is a small...

no oil pan dents good thinking though

Yes the ecu is obd1 Also i did not use a jumper harness i just pinned the ecu for the vtec. Tab got the diagrams for me on which ones to pin. Pretty sure i have it right. Does the vtec oil pressure switch always feed a positive signal or negative??

I recently did a swap on a 90 honda accord with a h22a vtec engine. Car runs great except the vtec is not engaging. From the wiring diagrams i got off hear it's pretty sure i have them pinned right to the ecu. What i'm getting is a constant ground from all three sensors even when the vtec is...

how did you secure it just stick in a few bolts i'm having a hell of a time without pinching the damn wires??

I have an automatic too and i tried doing what you said and it works pretty well. I compared it to my 92 prelude that has the same motor and noticed little difference. Advancing the timing seems to make up for the low end torque. Maybe down the road if i come across one i'll stick it in...

ok great how well does it work in your opinion?? I sent the pics as well.

Also just send me your email address and i'll send you the pic because i'm terrible when it comes to that stuff thanks

how well did the little trick work and how did you by pass it

hey how do i load a picture up for you on this web site

Yeah i will get the picture to you tomorrow TAB, i have to load it up. I wanted to ask you a quick question though. When my engine arrived the IAB was broken. I did not wire it up and eliminate dit completely. The car runs fine and the vtec is working as well. It also did not set a check...

yeah your right thanks again for the help take care

nevermind i got it to work thanks

hey TAB it still will not let me view the pics on the hondaswap website. Can you please just send a brief description of what needs to be done with each of the pictures. Also from what i understand i only have to run 4 wires to the ecu correct? Knock sensor, Vtec solenoid, Vtec oil pressure...

TAB i can't get the damn pictures to load up now. Can you send them to my email for me. khs128@psu.edu. Thanks and i'll telly uo what i think, but i'm sure there good to go.