Recent content by xela_127

ok thanx for reply....first of all....my temp gage looks like it's working properly cause like i said when i press the pedal to the metal with the first fan switch unplug the temp does get to the operating temp(to what it was before it breaks) and if i slow it down or go on the highway in a long...

hey guys!!! i've had the same problem all winter and now i'm really getting pissed!!! my car just won't heat up!! though it was the thermostat so i take it off put it in boiling water and it seem's like it works just fine!! so bleed the system again!! and then i realize that the fan go on when...

hey guys, i got a erratic idle problem. when it's warm and i rev it up high long enough when i get back to idle pass from 750-1250 rpm continuasly till it finally stop and rev at about 900-1000rpm. i screwed the fast idle valve to it's maximum clean the IAC chek my O2 sensor signal visually...

i would tottally agree with that they are not the same!!! not on canadian model anyway! thanx for all i'll be running the car today thanx!!!

ok i went to napa today to get to good drive-axle. when i ask for an accord one they gave me a 2 male end axle. so i ask i'm to see what the prelude 1 look like and it has 1 female end with 1 male end.(finally the one i needed). so how come all of you guys tell me that accord axle would fit...

ok thanx guys i think that they sold me the wrong drive axle even though i chek the part number to be sure so i guess they must have a wrong listing thanx guys been really helpful!

ok thanx i'll try that tommorow morning (i'll call napa to see if the prelude axle is female at the half-shaft end) can you answer that question? any 1 else got something to say?

hi guys thanx alot for all the answer you provide me they have been really helpful. but there'S one thing wich ain't right. i wrote a topic about axle and half-shalf. let me remind you. i got a jdm lsd tranny that came with the half-shalf. i was running automatic now it's manual. the axle on the...

hi guys thanx for reply on the other post would like to ask you couple other question(by the way i got the engine mount thx) :) jdm h22a 95 swap into accord 94 1-the fuel line and return line; would like to know if the fuel line wich was connecting to the side of the fuel rail on the accord can...

hi guys would need a real good answer to my question. i mount the h22 driver side mount by grinding it a little bit. i mount the passenger side mount (wich is h22) looks good!! so when i get to the front i can't figure wich metal braket(h22 or accord) i have to put on my accord mount. seems like...

thanx guys but i'm not so sure. right now what i'm going to try is for the front mount (accord) with accord braket, passenger mount (h22) rear mount (h22) with h22 braket and h22 for the driver side. any 1 can tell me if that would work or do i have to use front h22 braket with accord mount...

thanx , so if i understood i could use both prelude or accord mount and axle as long as they came out of manual tranny? also what did you do for the power steering i read somewhere i could splice the lower accord with upper prelude line or have a 97 prelude power steering line and it would...

hi, i'm new to the forum since i just started my swap! my question is wich axle can i use on my accord chassis with h22a lsd. can i use the prelude axle and intermediate shaft or do i got to use the accord axle and shaft??? also my car started as a automatic and now it's gonna be manual so i'd...