Search results

  1. D

    Overheating problem 94 honda civic dx

    Do a compression check that should tell you if you have a bad head gasket. by what your describing it sounds very possible.
  2. D

    Injector resistor question

    I have heard a few people make refrence to using resistors from radio shack instead of resist boxes. 10ohm 20watt i belive. I have had trouble finding information on how to wire them in. I am assuming they would just be in line with the injectors. Anyone know how they are wired or where i...
  3. D

    NYS ecu swap question

    I have cleared the code 5 or 6 times in the process of replacing parts. My concern here is the NYS inspection laws. I don't know if i can just switch ecu's and have it pass inspection because NYS inspection computers will think it's a different car.
  4. D

    NYS ecu swap question

    How do you go about getting your car inspected after you install a Used ecu. I know with the new laws you cant just swap ECUs, obd2 anyway. I heard I would have to take the new ecu to a honda dealer and they can reprogam the used ecu with my VIN so it would belong to My car. Anyone know exactly...
  5. D

    O2 sensor removal tips?

    ok man I found a really good site to buy o2 sensors from its www.oxygensensors.com the prices are awsome. I usually buy the universal ones and use the plug from the old sensor. If you know someone with a tourch borrow it and heat the area where the sensor screws in the manifold. Then try turning...
  6. D

    b20b compression test

    the carbon build up wasn't bad. I suppose i should do a leak down test.
  7. D

    Removal of a rounded bolt?

    if you can fit one in there a pipe wrench works well for this too. Cuz the harder you twist a pipe wrench the harder it bites down.
  8. D

    b20b compression test

    I didn't run it. I was trying to ask if the engine not being warm could cause a fluctuation like that. It is not a fresh build although i did remove the head install a block guard then reinstalled the head with a new head gasket. I just wanted to compression test it before iwent much further...
  9. D

    b20b compression test

    Just did a compression test on my b20b with mixed results. cylinder 1 and 4 are both around 190 but 2 and 3 are 160ish. I did a block guard before I swaped it in, so i probably caused this problem. My question is... I was unable to run the engine to get it warm before I Tested it(fresh swap...
  10. D

    b series axel question

    I have 95 sol and I am swaping in a b20. Motor is in and i have just gotten to the axles. I have a 94 vtec del sol axle for the passenger side(right side). Will this axle work or do i need one from a 94+ teg.
  11. D

    wtb 94+ integra starter

    the title says it all. I need a starter from a 94+ integra I am doing a b20 swap and have a 94ls tranny on it. I need a starter that will work on it.
  12. D

    B20B motor mount question

    sweet....this guy saved the day for me. thanks boostedek9
  13. D

    B20B motor mount question

    Anybody??
  14. D

    B20B motor mount question

    Ok heres my problem. I bought Avid racing b series to 92-95 civic swap mounts like 2 yrs ago on ebay(finally getting around to the swap). The auction said that it would work with any b series motor. Well the driver side mount that comes off of the engine are not even close to lining up with the...
  15. D

    What shift linkage

    cool thanks for the help people :D
  16. D

    What shift linkage

    cool thanks Are the other parts gonna be the same. The parts attached to the car anyway? I won't need to get all that stuff right just the 2 rods.
  17. D

    What shift linkage

    I actually was looking here https://www.hondapartsdeals.com/honda_parts...component=B++34 But thats beside the point. Do I only need part 13 (ie just the shift rod) or do I need both rods?
  18. D

    What shift linkage

    Do I have to get the shift linkage out of a vtec del sol or will others work? I have heard 94+ teg will work but i will have to lengthen it. How hard will it be to lengthen. Is it worth it to pay for a new one from honda? I ask because getting a linkage from a vtec del sol is almost...
  19. D

    CEL and a blown fuse

    Its a 7.5 amp fuse marked sp sensor/alternator. I actually found a remote starter that was kinda cobbed in so I took it all out hoping that was causing the problem...no luck. Looks like Im gonna spend the weekend chasing wires :(
  20. D

    CEL and a blown fuse

    Ok its a 1997 civic dx hatch. No swaps or anything completly stock. Its my daily driver and it keeps blowing fuse 15. Its the fuse marked sp sensor/alternator. So my speedo will quit and i get a cel. I had the alt tested at advanced auto and it tested good. When the fuse blows all the...
  21. Try your Search on Google

Back
Top