Search results

  1. T

    94 cx /w b16

    I am have a bad driver side axle that I need to replace but am not 100% sure as to what axle I need to replace it with. Do i just get a 99 Si axle or a dohc del sol's. Any help on to what axle I need to replace the bad one on my sir II swap in my EG.
  2. T

    Clutch not disengaging fully Help!

    I had the same problem /w my sir II swap. I took the tranny off and found out the clutch had pieces broken off it and they were loose inside the pressure plate. Thats what was causing me not to be able to engage the clutch all the way. If it has that many miles you may want to check and see...
  3. T

    EG hatch suspension set up

    I will be driving the car mainly on the track and not very often on the street. And want to spend around or under 900-1000. So I want your guys opions on what the best track set up would be for my money.
  4. T

    EG hatch suspension set up

    I know it has been talked about 100 times and am I sure you are all sick of hearing the same questionk, but for bettering of my knowledge I would like to ask the age old question of what suspension set up would be best for my hatch. I will be driving it on the track this summer and a little on...
  5. T

    B16 sirII not starting!

    we tested for spark and we are getting it, I will try a smaller gap but I don't think that would keep it from starting completly. I also should definatley check timing. Any other suggestions?
  6. T

    B16 sirII not starting!

    I just used my stock cx wiring harness and converted from a 1 wire to a 4 wire O2 sensor and add vtec wires. I didn't know there was a diffrence.
  7. T

    B16 sirII not starting!

    Ok I just finished getting the motor in my car this weekend and double and triple checked to make sure evething is hooked up right. Then I went to fire it and it won't do anything execpt keep cranking and cranking, not even a putter. I replaced Dis. cap, rotor, plugs gaped my plugs at like .050...
  8. T

    $50 for the answer!!!

    My B16 SirII doesn't have one either, when I took the hose off of the one on my old sohc, I didn't have anywhere to put it on the B's intake manifold.
  9. T

    Plug gap

    Ok I got my B16 in my car this morning and tried to start it and I hear the fuel pump priming and it is cranking, also when I took the plugs out they have fuel on them. I am going to go buy new plugs and dis. cap. My question is what should I gap my plugs at on a B16 P30?
  10. T

    ECU Pins

    are all the pins in the harness that attaches to your ECU the same in all generations. I know there are big and small ones. but besides that are they all the same?
  11. T

    ecu pin removal

    do a search there are pictures people have posted to make it easier
  12. T

    ecu pin removal

    there is a plug that has two wires coming off of it and it is not pluged into anything, you stick a piece of metal into both of the slots so that you complete the circuit. I use a paper clip, then you turn your key on to acc. and count the blinking lights 1 long=10 1 short=1, there will be...
  13. T

    cant fing hose for sirII swap

    Yeah go dealership, you know you will get the right ones. hey you pay for what you get.
  14. T

    swap b18c5 help?

    First go check the codes for us so we know exactly whats wrong.
  15. T

    Buddy Club

    thanks will do
  16. T

    Buddy Club

    Has anyone heard anything bad or good about Buddy Club spec cams, specifically the spec 3 plus. Thanks
  17. T

    SIRII in 94 civic ex (OBD1)

    inlinefour.com sells throttle cables or check a honda dealership for doch del sol one
  18. T

    B16 SIR II into 94 cx hatch

    Oh yeah and by the way 92b16vx the zip tie is by far and above the most gansteress way to make the cable work!! :worthyp:
  19. T

    B16 SIR II into 94 cx hatch

    They do have a guarantee on those sensors and I am sure if you called them on the LSD they might give you some compensation, they are out to please.
  20. T

    SIRII in 94 civic ex (OBD1)

    Or if you buy the complete from HMO then the axles it comes with work and so do the mounts, you just need a new throttle cable or make a bracket, because your D16 throttle cable won't work. And you also need 94-97 DOHC Vtec Del Sol radiator hoses to hook up you rad. I think your good from there.
  21. Try your Search on Google

Back
Top