that dose sound kinda dumb, because that I can plug the ECU into the car just fine I have a OBD0 to OBD2 conversion harness, but I can't plug the engine into the car...
All right I have ordered the OBD0 to OBD2 conversion harness, so that covers the ECU side of the wiring, now what about the engine side??? anyone know where I can find info on converting a SI\HF to a OBD2 engine (Y8\Y5)
I know there are a few things that will need to be re-wired just by looking...
OBD1 and OBD0 not an option. I HAVE to use the P2J ECU for this engine to work properly. so I NEED to wire my car for OBD2. Haven't beean able to find a OBD0 to OBD2 jumper harness... any one no where I might look to find the Wiring diagrams for OBD0 and OBD2...
Ok so heres what I'm doing...
96 obd2 3-stage vtec D15b.
I just located the proper ECU. now what?
there are so many wires on this thing... and the only plugs that plug into
anything are the ECU plugs....
I assume this would be about the same as putting a Y7 or Y8 in a crx.
where do I start...
Are you ready for this. I have a 96 D15b(OBD2a) and I'm trying to wire it to a OBD1 ECU. What all do I need and where does it all go. thanks. oh and this is a 91 crx HF... Have both harness and a OBD1 ECU and Jumper harness already.
I need the dash, the door panels, upper rear trim, center console, inside door trim and right front pillar... and the rear bumper support, where are you located?
email me at Freaze_or_bUrN( at ) yahoo(dot) com
ok this is all here say, but ... I have heard that you can swap IF and only IF you swap the pistons aswell, you only have 8 valves on you hf, and you only have 8 valve reliefs on the pistons... if you swap the si pistons you'll get a f*cked up CR (like 14) and you'll go Hella fast... but not...
I also need the rear bumper support, the drivers side window crank mechinism, and lots of black pieces, please email me.,
Freaze_or_burN "at" godmail.com
The interior is black right?, I'll give you, 100$ shipped for the dash, 25$ each for the lower door panels, 40$ each for the whole door panel, and 15$ for all the upper trim in bach and the door stills. I think thats all I need, Where are you located??? could i pick up or meat you some where...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.