Search results

  1. 1

    cel 23 wtf????

    no one incounter this problem before?
  2. 1

    cel 23 wtf????

    yeah i know its for a b16. traded a pm6 for it. didnt have money for a conversion harness. its running rich but the knock sensor code is a little funny to me. does the bypass only work at night. cause the cel doesnt come on at night. any thoughts?
  3. 1

    cel 23 wtf????

    also i did the knock sensor bypass using a resistor and ground.
  4. 1

    cel 23 wtf????

    this is a weird problem. the knock sensor cel comes on when is drive with the lights off. but when i drive with the lights on no cel...ideas of what it could be. by the way i have a 91 crx si with d16z6 and running a pr3.
  5. 1

    b18a1 swap

    thanks
  6. 1

    b18a1 swap

    just finished installing the engine. just making sure there are no ecu pin changes that all.
  7. 1

    b18a1 swap

    just finished a ls swap. wanted to make sure obd0 pr4 is direct plug in to a 91 crx si. do i need to change any pins??
  8. 1

    Moto Has No Spark?!?!?

    got spark plugs in?
  9. 1

    Moto Has No Spark?!?!?

    any codes?
  10. 1

    ecu question

    any down side to using a pr3 with d16z6?
  11. 1

    Moto Has No Spark?!?!?

    i always get my rotors from honda. had bad things happen when i got cheap rotors.
  12. 1

    Z6 Swap Wiring

    obd0 or obd1
  13. 1

    resistor box

    so it would be best to use the ls box with ls injector rather than crx box with ls injectors
  14. 1

    resistor box

    so you dont need to swap the resistor box if you are running ls injectors.
  15. 1

    resistor box

    are there any differences in resistance between integra and crx resistor boxes?
  16. 1

    Ignition Coil Code! Wont Start!

    *if so make sure you dont have the two white wires on the 8 pin connector.* i ment make sure you dont have the two white wires crossed on the 8 pin connector
  17. 1

    Ignition Coil Code! Wont Start!

    . if so make sure you dont have the two white wires on the 8 pin connector. i ment make sure you dont have the two white wires crossed on the 8 pin connector
  18. 1

    Ignition Coil Code! Wont Start!

    the slots on the cam are offset to prevent the dizzy from being mounted 180 deg. off. "I'm searcing this board with the same exact problem. Code 15 and no spark. Also no 5 VDC on the sensors or ELD. Did you figure this out?" is your wiring spliced to the dizzy? if so make sure you dont have...
  19. 1

    need swap help

    figured it out. i was looking over the engine and saw backfire through the intakemanifold. shut it off and what do i find. my dumb ass over looked a piece(bout 1.5 inch square around a stud on top of the #3 cylinder) of the old intake mainfold. took out the piece and the engine is running like a...
  20. 1

    need swap help

    anyone
  21. Try your Search on Google

Back
Top