for the starter? were how? i looked high and low and the only conclusion i come up with it that the starter doesnt have power going to it. and im thinking its the starter relay. how do i check a relay? any help would be great thanx.
it wasnt their i put that their i have fuel now yahoo.
but now i have no power going to the starter? what fues that would be?
and my car makes alot of clicking noises when i try to start it comes from behind the glove box? i would have to play with the ignition switch on and off till it goes of...
ok im working on a swap right now as i was puting in the axels i notices that the wheel spins very easly and then i realized that its in gear and it has no effect on the motor. im really worried i put a new clutch in exedy stage one. i have no trans fluid in it yet could that be the problem, i...
i know the one on the thermostat is on but the one on the transmission were would that be located? i dont remember having a ground on their is it like a plug cuz i think i might hace like 2 plugs on their i dont remember i pluged everything up and then droped the motor in.
ok this is my very first swap i did everything on the car its a 96 civic ex obd2
i put an obd1 b16. p 30 ecu with the conversion harness. i almost finished the car. i just need to put the radiator in and axels and the o2 sensors too call it a day. my problem is when i went to crank it i didnt...
ok i was doing an b16 obd1 swap in my obd2a civic ex as i was altering the wiring harness i was going for the clean look so i choped the wiring harness from where all the wires go to under the intake manifold i know each injector has two wires. my prob is that every injector has a yellow with...
yea do b16 great way to up grade plus you can do tons of things to a b16 then the engine you have in your car im working on my swap as well. with the b16 swap your looking at 3 grand a engine and trans 2 k new clutch 300 bucks axels 300 bucks shift linkage like 50 bucks used and many other...
i say swap, save you alot of $$$ and labor. thats what i would do unless you wanna make one nasty motor were you would put in new low compresion pistons rods, bearings and turbo to go with that low compression setup;) if the cylinder walls havent been damaged of course.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.