Search results

  1. T

    code 22

    after i reset the ecu i get code 22 a few seconds after i start it, neither pin has continutity to ground with the car off
  2. T

    code 22

    when does the ecu send 12v all the time
  3. T

    code 22

    can to much oil cause code 22?
  4. T

    code 22 b16a

    I just wondered when does the ecu send the 10V to the vtec pressure sensor, I have continuty between the 2 pins on the sensor, but i'm not seeing any voltage come from the ecu. I disconnected the wire at the ecu, and there is continuty through the wire, but i never saw any voltage, just the...
  5. T

    zc injectors

    if the map sensor is malfunctioning would that cause no fuel to get in??
  6. T

    zc injectors

    should i check right at the resistor box?? i checked accross the injector plug while the car was running, all it said was 13 volts, but i was told the voltage chages to quick for a multimeter to catch it. also the d16a6 i pulled out of it was running perfect as well, other than puffing white...
  7. T

    zc injectors

    I tried 2 different injectors, d16 and zc injectors the same???
  8. T

    zc injectors

    alright i swapped a zc in a 91 civic si, and i'm not getting fuel to the # 1 cylinder, but all others are firing I wondered do injector resisitor boxes go bad alot, and if it's possible for only one injector not to get a signal?? are the injectors the same as the d16a6??? I tried already...
  9. T

    93 civic dx with mini me

    i guy in my area is selling a 93 civic dx with mini me swap not running. he said he replace dizzy, wires cap rotor , fuel pump but it won't start. he said he doesn't have the vtec wires run yet would that be the reason that it won't start?? it turns over, any other things anyone can think off??
  10. T

    zc motor

    no check engine lights, code 20 flashing, you don't think the timing is off at all??
  11. T

    zc motor

    I just recently swaped a zc in 91 civic si and it seems like it is running a little rich (i smell gas when it's running and it shakes quite a bit) what do you think the problem is?? would it do this if the timing is out a tooth??? and more ideas would be great
  12. T

    tranny question

    I'm not sure what happened but it works now, when you pushed the clutch in halfway you could put it in gear. So i stated to drive it and somehow after a couple rotations of the tires it started working normal again thanks anyways
  13. T

    tranny question

    any other ideas, i tried playin with the cable and nothing????
  14. T

    tranny question

    cable clutch
  15. T

    tranny question

    i just did a swap and when the car is off the car goes in every gear fine, but when the car is running it will not go into any gear, it's a 5 speed si tranny bolted up to a zc motor(5 speed manual), any idea's, i just hope I don't have to take the tranny off????
  16. T

    zc questions

    there is already a hole that looks like it got torn, proably about 3 inches in diameter, should I cover it up or just not worry about it??
  17. T

    zc questions

    i have to questions, 1 what is the firing order of the dohc zc???, and 2 when putting in a cold air intake system should i cut the piece of plastic off under the front bumper to totally expose it ???
  18. T

    zc vacum lines

    i just recently swaped in a zc motor to a 91 civic si and the zc intake manifold looks like it is missing a sensor on the back of it, and also a vacum line which is right around this sensor, is this correct or am i just missing something
  19. T

    timing the zc

    go to the site ZCspeed.com there is a write up i seen on there
  20. T

    91 crx seats into 91 civic si

    do 91 civic si and 91 crx si have the same seat rails or are they different?? the guy told me the rails are different??
  21. Try your Search on Google

Back
Top