this might sound like an ass question but im curious. I have a b16 distributor with no cap and rotor. I have a d16y7 dizzy with cap and rotor. apparently the rotor fits perfect but the cap does not. Simple question- if i get a b16 cap, will it work with a y7 rotor? this is asking for flamage...
i need help my motor cranks and starts but boggs out and dies after 10 seconds or so. I have fuel and spark. I am thinking this is due to my MAP sensor because i spliced the plug from the main harness as i have a DX chassis and engine wiring harness. There are 3 wires a pink wire a yellow/green...
im in the middle of doing my swap and i have some problems.
1)The rear T-bracket or rear tranny mount does not stretch all the way to the rubber bushing its supposed to bolt up to in the rear of the compartment. In other words its too short to reach the mount in the rear. I used the t bracket...
ok i have a y7 in my EG with a z6 trans. my problem is that my rear tranny bracket does not stretch back far enough to bolt to the rubber bushing on the crossmember. the car previously had a b18 in it and i know the tranny side mount of that piece is different coming from the engine. my question...
I know its been discussed but i need specific answers
1. I have an obd1 harness and an obd2 harness which is easier as far as making the car run all right?
2. If yes to obd1 harness, do all the plugs fit as far as the sensors and electronics go? which ones do i need to alter to work with the...
iI couldnt really find anything conclusive so heres my question. I have a 93 B18a and i have a 95 gsr trans. Its going into an EG. I have axles off of the EF that had the motor before my car did. Can i use the cable trannys axles on a GSR trans or do i need new axles? or is there some way to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.