Search results for query: *

oh and what would i have to wire ? vtec , vtec pressure switch?? what else

okay so im back in the scene i got a 96 prelude a couple months and a f20b came up for sale pretty cheap there is not alot of info out there because it the euro i eas trying to get this motor but i need a little more info and what u guys think .. i motor comes with ecu but its an automatic so...

SPC balljoints, Alignment With Rear Toe Maxed - Honda Prelude Forum

timing is good check to make sure . but it was the missing blue wire coming out of the dizzy in the 6 wire plug!

okay so i found out what it was after i was going to replace the dizzy the wiring harness connecting to the dizzy was all rotted and one of the wires had broken off thanks to every one that put there 2 cents

92 civic obd1 b18a1 pr4 ecu

4 ckp inside the dizzy right

by the way i have a swapped ls in the hatch with pr4 ecu

okay so here is the deal i was on a road trip down shifted to past some semis at about 100 mph bang booom wam!@ my car jumped to limp mode. It would not rev past 3200 rpms sound awful so i truned my car of and it was fine started driving again and every time i hit 5k rpm limp mode so i just...

wow i have never been happier to here a car run and rev up this today! wait my ls swap eg was a good feeling to...lol . anyways today i received the part and everything turned out great car runs awesome now!!!

yeah i did s a lot of googling and checked the plug could not find how to test it! it had some oily grease on the plug cleaned still same. i got the car like this the guy who had it had it the same way just didnt even want to mess with it today i today i pulled it all apart one of the sensors...

po335 snap on scanner

okay i know im not in the right thread but can anyone shed some info on this! i just got a 96 prelude mt. 2.2 non vtec and it will not rev past 3000 rpms. now i check the codes and i have a bad cps but would that not let it rev past 3k!!! what else should i look at? it dose not miss start up...

so i got a 96 prelude mt 2.2 sohc and it will not rev over 3100 rpms. thought it was in limp mod pulld codes and i have the cps code will that cause the motor not to rev over 3000. any one have any idia on this could it be the tps?????

okay i swaped the d15z1 out of a friends hatch for a d15b8 but the wiring harness that came with the motor did not have any wiring for the map sensor and its throwing the code for it and wasting hella gas so i wanted to know if anyone new the easyest way to wire the map sensor to the car!!!

cool i have my old dizzy still

sucky guess i have to buy a new coil.............

were the hell am i getting the spring lol...........

its about 1/4 inch in there am i missin the spring