I have a 95 civic dx with a sir-II swapped in it. I'm using a p30 ecu. When im driving and try to accelerate quickly it feels like my engine starts to misfire very bad to the point where the car jerks. I have only code 7 shown which is the tps. I changed it but still it does the same thing...
Put a JDM b16 sir-II in a 95 civic and it is throwing a thrott;e position sensor (7). So when i go to jump on the throttle the engine will bog out and sputter. so if anyone could help me out with testing the sensor or if there is another way to fix it. Thanks
Now my jdm sir-II motor will not start. I looked at the crank and cam gears to find tdc but the white line on the crank is not pointed up when the cam gears are up. Could this be why my car wont start.
I just finished installing the sir-II in a 95 civic dx. All my wires are added and I am using a p30 ecu. When I tried to start it, it would just crank over. I didn't wire a knock sensor. Also the map sensor and evap purge are hooked up. I have spark but after cranking it I pulled the spark...
Does the connecter for the vtec pressure switch have 2 wires and if so do I have to add both to my harrness. SiR-II in a 95 civic dx. Any pictures would help
Can you tell me what the solenoid looks like or where it is? Can I pull the wires out or is their a special way to get them out? What about the pressure switch?
im putting a sir-II into a 95 civic dx and am using a p30 ecu. How do i connect my old harrness to the new engine. Also where can i find a Helms manual. Thanks.
I just got my JDM SiR-II in and it is going in my 95 civic. I know I have to replace water pump, timing belt, plugs & wires, cap & rotor and tensioner pulley. Now it came from hmotors and all of the hoses and wiring harness are cut. Do I have replace the hoses or can I use the ones from my...
I have a 95 civic dx and putting in a JDM b16. I am ordering it from hmotors and i want to know what i will have to do as far as wiring it up. Can someone tell me what i must add and how to go about doing it please. Any pictures would be helpful.
I have a 95 civic dx 5 spd. Im getting a JDM SiRII front clip. It comes with everything under the hood including the ecu and engine harness. Can I just plug and play the JDM harness into the ecu and engine or is there other wiring needed? Also am i able to use the axles that come with it?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.