Sometimes you can take a small propane torch and heat the small end. This will cause the opening to open up a little more and allow the wrist pin to come out. Just keep the heat off the piston.
Ok. I am helping my son build a D16Z6 for use with a turbo. He bought this motor all machined and ready to build. The pistons say 0.50 on top of them. I am assuming this is 0.50 over bore, but I am an old Chevy race motor builder and new to the import sport. He has been told he has to buy a $150...
I asked my son how the guy got the Z6 to hook up to the old Y8 harness, and he said the guy " modified" :angry: the harness to work. I am sure this is the whole problem now that I know the whole story. I am not sure where to go from here. I guess I will have to buy the obd0 to obd1 adapter, the...
Well he tried using the ecu that was in the car the z6 came out of. He said it was an obd1 computer. When he hooked it up his car would not even start. Can someone point me in the direction of how to hybrid a z6 into a 1990 Civic SI 5 speed with the obd0 ecu? This might be my easiest route is to...
Ok....here goes. I have searched but did not find anything like my situation. Sorry if I could not find it. My son bought a 1990 Civic SI with a 1996 1.6 L D16Y8 Vtec in it. The motor went out on him and he bought a 1995 1.6 L D16Z6 and had a friend put it in. The motor will not run right. It...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.