Search results

  1. U

    This nut is a pain to get off..

    what i usually do in a situation like this is take the whole spindle off and including the cv axle (driveshaft) and go to a junk yard and get another spindle and buy a driveshaft at a parts store that way you have a good wheel bearing and a new driveshaft..
  2. U

    axle nuts!

    i just telling you man i do front end alot at work just remove the spindle with the axle and buy another spindle at a junk yard.Since you replacing the axle anyway and you can get money from the old spindle with the axle connected to it.done it plenty of times before.even if you do have the...
  3. U

    axle nuts!

    i had the same problem the driveshaft would just not move at all (we impacted it,used a breaker bar, used a torch )and nothing worked so what we did was we removed the upper and lower ball joint and removed the outer tie rod end from the spindle and we took off the whole thing wheel spindle and...
  4. U

    frankenstien civic

    ok thanks man
  5. U

    frankenstien civic

    i tried that already i buddy of mine from work told me to do that and it did but if my car is obd 1 how would i be able to erase the codes just by connecting the two terminals in the blue clip on the passenger side or what?
  6. U

    Where to get pad retainers?

    buy a hardware kit for that particular car model make sure it the right one those retainers clips are used to force the pads outward away from the rotors which will help with wear of the pads and noise
  7. U

    Whats wrong with my brakes?

    do a line test on the master cylinder they way you do it is you put line clamps on ALL the brake lines going towards the calipers or wheel cylinders after doing that pump up the brakes till it gets hard and then start the car.put pressure on the brake pedal and if it starts going to the floor...
  8. U

    SQUEEEEEEK! Help please!?

    did you check your cv axles? that could be the problem
  9. U

    Gsr shaking bad!!

    check in 1st gear and reverse or drive and reverse while stepping on brake so you dont accidently run over your friend.hahah
  10. U

    Gsr shaking bad!!

    the way i was taught to check mounts on a vehicle is to put the car in gear and step on the brake, give the car a little gas while half clutching, sort of like drifting and have a buddy of yours look under the hood with a flashlight or whatever check the mounts if there is any major play in them...
  11. U

    frankenstien civic

    soory man i am a noob and i didnt know where to put it at.
  12. U

    frankenstien civic

    thats gonna be a problem cause last time i checked there was only a connector for 1 o2 sensor on the harness i read that there should be one before and after the cat but mine exhaust is 3" straight pipe with no cat.
  13. U

    frankenstien civic

    i have a 93 civic with an 98 integra intake manifold and head with an civic si wiring harness. the car runs great but the cel light is always on,i am new to hondas i dont know much about cars but my question is what would cause my cel to stay on i checked the code and it was shooting out an 02...
  14. Try your Search on Google

Back
Top