Search results

  1. B

    Wheel Shimmy/Shake under Load

    When you said you had up and down play were you holding the joint itself or the shaft of the axle? If the joint then your play was coming from the differential bearings. If the shaft then that was axle play. When you say your axles don't spin, meaning you cannot turn them by hand or just with...
  2. B

    Bad Pr3 ECU????

    Thanks guys, I will try all your suggestions! I guess I was telling myself that it couldn't be a bad ECU because, I don't want to delay the swap any further! Josh :D
  3. B

    Bad Pr3 ECU????

    C'mon someone has to of had a bad ECU before! Josh
  4. B

    Bad Pr3 ECU????

    OK here is the deal. Did a B16a swap into a 91Ls used the Ls harness on the B16a. wired up VTEC, plugged in Pr3 ECU and I get no fuel. I think I may have been sent a bad ECU. I plug the pr4 ecu back in and the b16a fires right up. I know this seems like a no brainer but I want to make sure. I'm...
  5. B

    JDM B16a vs. USDM B18a engine harness

    Problem solved just reused the Ls harness. The third plug was something to do with the fuel pump. Josh <_<
  6. B

    YS1 INTO B16

    correct me if I am wrong but The ys1 was only 92-93 and they were offered two different ways in Ls form with tall gears, and short gears for the Gs-r. And for the record the splines are different from 88-91 to 92-93.
  7. B

    JDM B16a vs. USDM B18a engine harness

    yes both are obd0! Josh
  8. B

    JDM B16a vs. USDM B18a engine harness

    Hey guys I was just wondering if anyone knows the difference between the JDM B16a engine harness and USDM B18a engine harness. I am in the process of a swap and used the JDM harness, only to find out they are slightly different. The only problem I found is near the resistor box there are 3 plugs...
  9. Try your Search on Google

Back
Top