Search results for query: *

18 INCH RACING HART'S 4X100 FOR SALE. 1 MONTH OLD 215/35/18 TOYO PROXES. RIMS HAVE A MINOR CURB SCRATCHES BUT NO CRACKS BENTS. RIMS STILL SHINE! BUT JUST A LITTLE TOO BIG FOR ME NOW. ASKING $1000 OR WILL TRADE FOR 2000 SI WHEELS/TIRES AND $400. LOCATED IN LAREDO,TEXAS. BUYER PAYS FOR SHIPPING...

they should, i think when i bought my springs a while back it read that they fit any 92-00 civic i think even the crx...

ok well, i took everyone's advice and rip the sh!t out. still working on the vacuum lines and im having trouble shifiting, but ill figure it out once the cable clips that hold them in place get here..

im doin the same swap, if im correct from all the forums ive read, the jdm h22a p13 ecu cuts u off at 120. japan has a bad governor. im planning to burn the spoon ecu chip and that will elminate the governor, not to mention give u some more horsepower.

ok i just did the jdm h22a swap in my 92 hb si. i wanted to put the power steering but i dont know if it will fit, im using the hasport mounts. am i supposed to use the pwr steering of my original motor or use the one that came with the jdm h22a?

im doin the h22a swap into my 92 hb si and i got the swap axles available from hmotorosonline. they offer 90-93 Integra axles and 90-93 Accord Intermediate shaft with the swap. i put them on already but i noticed that their is very little clearance off the a-arms. did they send me the wrong...

i just swapped an h22a in my eg si hb. it comes with a p13 ecu as you all know, but i wanted to know that if i install the apexi rev/limiter, will it remove the governor of 120mph? hit me back

if you havent found the cable linkage yet, i have one from a 95 accord 5speed i believe. i bought the shift mechanism and the gave me the cables too. my jdm h22a came with the cables so im gonna use those with the accord shift mechanism so i guess i can get rid of the accord cable linkage. were...

ok i bought the 2 radiator hoses integra lower and delsol upper ( or something like that) but what about the one located just above the oil filter? what radiator hose do i buy for that one? i feel stupid saying it but i will just to get a few laughs out of it. i changed the oil on the motor, and...

i have a 2 week old compressor i had on my d16z6 that i swapped out. i usnew compressor for 2 weeks then switched out the motor. i bought the compressor from honda parts dept. for $480. employee cost. i work their so it wasnt as expensive. ill let it go for 300. i havent even paid for the damn...

well like i said , i ordered the one's they offered from hmotorsonline which are the 90-93 Integra axles and 90-93 Accord Intermediate shaft.

cool deal, i had a feeling it would work but i just wanted to double check. ill prolly cut the hole inside the floor board today.. thanks again.

well, ive been doing my swap since the beginning of october. ive had some problems finding some parts but the biggest problem was turning it on. we thought we had done the wiring wrong, till today i purchased the ignitor and switched the coil from my factory block distributor to my h22...

i havent got my swap done yet but i finally got the shifter mechanism from a junkyard in corpus christi,tx. its off a 95 accord 5 speed. they sent me the shifter cables and the shifter mechanism for 125 shipped. its sounds kinda expensive but i need the part. i was reading some froums right now...

i also have the jdm h22a motor mounts that are still in good condition. motor mounts are off a 92-95prelude. i guess ill sell for a 100 bucks, obo.

doesnt that brand ENJO make hi performance axles?

well i just did a swap a h22 a in my eg( that i havent been able to finish),but i need to sell the stock engine. its a d16z6 with about 80-90k miles on it. u would need to find the wiring because i used it toconvert my h22a wiring, but i do have the ecu. i will sell the motor for 350. i dont...

i got fuel running to my motor, but i cant get no spark. i changed the cap and rotor and still nothing. i figured out that their is spark to the distributor but no spark from the coil to wires/plugs. i have the jdm h22a so i have the internal coil. i have talked to techs and they said to check...

im doing the same swap myself on my 92 hb si. I have been guided through the :worthy: H22 BIBLE :worthy: as well and has helped alot. i got my complete swap hmotorsonline.com and they sent me the mount kit and the tranny cables were good,not cut off. u need to find the shifter cable mechanism...

i purchased my complete h22a swap from hmotorsonline.com. i paid the extra 200 bucks for them to send me the 90-93 Integra axles and 90-93 Accord Intermediate shaft. the motor is already in i i put the cv joints on but i noticed that their is maybe half an inch of clearance from the cv joint and...