1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

90 b18a1 swap obd0 in my 95eg hatch

Discussion in 'Civic and del Sol - EG and EK' started by puffnmagicdragon804, Jul 8, 2014.

  1. puffnmagicdragon804

    puffnmagicdragon804 New Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Jul 8, 2014
    So I have a 90 b18a1 obd0 block I just swapped into a obd1car everything I have on block is obd1 wire harness ,dizzy, alternator intake everything except block what can I do to make this compatible to run
     
  2. CAFROG

    CAFROG Honda Minion VIP

    Messages:
    4,411
    Likes Received:
    148
    Joined:
    Apr 5, 2009
    Location:
    NOR-CAL
    If injectors hook up to clips you're good. I think all you'd need is a OBD1 LS ECU.
     
  3. Briansol

    Briansol Admins Admin VIP

    Messages:
    21,448
    Likes Received:
    2,110
    Joined:
    Nov 18, 2007
    Location:
    CT
    "blocks" aren't any obd.... they are metal castings.
    The electronics on the manifolds,etc are what need to match. If you did all that, all you need is a p75 ecu. depending on what trim model your hatch is, you may need to convert the 02 sensor to 4 wire if your harness from plug to ecu doesn't have it. (only 92s did if i recall)
     
Verification:
Draft saved Draft deleted

Share This Page