1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

91 crx si b16a sir II swap wiring question

Discussion in 'Civic and CRX - EF' started by catfishracer4748, Oct 19, 2008.

  1. catfishracer4748

    catfishracer4748 New Member

    Messages:
    17
    Likes Received:
    0
    Joined:
    Oct 19, 2008
    I installed a b16a sir II in my 91 crx and I have one left over connector that I dont remember where it goes. It is a round white connector with two blue /red wires and it comes off of the cooling fan harness. Any help would be greatly apprieciated.
     
  2. HATCHET_HONDA

    HATCHET_HONDA scottie fizzle

    Messages:
    764
    Likes Received:
    10
    Joined:
    Mar 11, 2007
    Location:
    hobart, indiana
    i just looked at my 90 si hatch and it seems it goes to the A/C LOW PRESSURE SWITCH. it should be on the pass side of the engine bay near the condensor. look for a sensor connected to the A/C line
     
  3. catfishracer4748

    catfishracer4748 New Member

    Messages:
    17
    Likes Received:
    0
    Joined:
    Oct 19, 2008
Verification:
Draft saved Draft deleted

Share This Page