1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

91 dx b16a swap

Discussion in 'HYBRID -> ED-EF / DA' started by crxmansir, Dec 4, 2003.

  1. crxmansir

    crxmansir Junior Member

    Messages:
    6
    Likes Received:
    0
    Joined:
    Jun 24, 2003
    Location:
    In the mountains of GA
    I put a b16a in a 91 dx hatch. It is throwing a 15,ignition output signal, and will not start. I ran the two cylinder sensor wires from the dizzy to the ecu. C1 and C2. Are there any more wires from the distributer that need to be ran to the ecu. Does anyone know witch wire is the ignition output signal. Any help very appreciated. Thanks
     
  2. jlicrx

    jlicrx Senior Member

    Messages:
    1,891
    Likes Received:
    65
    Joined:
    Jun 5, 2003
    Location:
    Colorado Springs
    ignition output signal is a white wire from the distributor - branches into 2 wires in the harness and connects to ECU at pins B15 & B17 - if you did the DPFI to MPFI wiring changes (using the DX harness) the cylinder position sensor wires are the only ones added at the distributor
     
Verification:
Draft saved Draft deleted

Share This Page