94 Cx W/ B18b

[Grocery(7ett2]

the motor i ordered did not come with a carrier bearing, i'm told that i need a jdm bearing for the motor, and different axles to fit the spindles in the car since its a CX, but not if it is a DX? any suggestions

thank you

 

[E_SolSi]

bill just put a LS engine in his 94 CX he used the LS axles it worked fine

 

[Grocery(7ett2]

The thing is, I was told that for the cx/vx models the hub on the car for the axles would have to be switched out to fit an integra axle....still the biggest problem is if a usdm carrier bearing can be used in place on a jdm motor, I asked at a shop and this guys knows alot esspecially about simply swaps like this and said it should....key word:should anyone have any ideas

 

[xj0hnx]

Originally posted by Grocery(7ett2 Posted on Jun 20 2003@ 07:36 AM
The thing is, I was told that for the cx/vx models the hub on the car for the axles would have to be switched out to fit an integra axle....

You were told wrong. I am using a teg axle on the drivers side (because my B16's was bad) and the B16 one on the passenger side. The 88-91 HF is the one with the smaller axles.