1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

a little help please

Discussion in 'Engine Building' started by DA69, Mar 5, 2004.

  1. DA69

    DA69 Senior Member

    Messages:
    340
    Likes Received:
    0
    Joined:
    Apr 18, 2003
    Location:
    psl Fl.
    i want to place ferrea 1mm oversized valves in my b16a head. i have skunk springs and retainers and itr cams. my bottom is an ls with .25 overbore and ctr pistons. here is my question. i was told to run this setup with the 1mm over valves, i need to modify my pistons. is this true? if so what do i have to do? also the head has been shave 20 thosanths. thanx
     
  2. pissedoffsol

    pissedoffsol RETIRED

    Messages:
    49,693
    Likes Received:
    53
    Joined:
    Sep 28, 2002
    Location:
    Retirement Home
    you're going to have to cley the motor anc check for clearences.
     
Verification:
Draft saved Draft deleted

Share This Page