1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

AEBS Intake Manifold install on B16

Discussion in 'HYBRID -> ED-EF / DA' started by CarAudiophile, May 23, 2004.

Thread Status:
Not open for further replies.
  1. CarAudiophile

    CarAudiophile Senior Member

    Messages:
    1,245
    Likes Received:
    2
    Joined:
    May 23, 2004
    Location:
    Omaha, NE
    Just wondering if anyone has installed one of these Intake Manifolds yet?. I purchased one about 3 weeks ago and I am going to be installing it soon. What kinda things am I going to be running into when upon installing this.

    Just curious if anyone else has done this on a OBD0 motor and what problems occured when installing this.

    Thanks.
     
  2. brian11to1

    brian11to1 Senior Member

    Messages:
    9,203
    Likes Received:
    21
    Joined:
    Jan 9, 2003
    coolant lines to the IM are a pain. The little "L" bracket is sometiems hard to reach.
     
  3. joesefcivic

    joesefcivic Senior Member

    Messages:
    130
    Likes Received:
    0
    Joined:
    Dec 8, 2003
    but is it on there? cause if im going to pull the manifold off on mine then im going to pull the complete head. and do some head work while its off. then reistall with manifold on there.
     
  4. GSRCRXsi

    GSRCRXsi Super Moderator Moderator VIP

    Messages:
    9,623
    Likes Received:
    345
    Joined:
    Nov 13, 2002
    Location:
    MD
    This is not Swap-related. This is the Swap-related forum.

    Try again in the right forum.

    :locked2:
     
Thread Status:
Not open for further replies.

Share This Page