1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Any DIY On Head & Block Building ?

Discussion in 'Engine Building' started by boostedhks, Oct 1, 2008.

  1. boostedhks

    boostedhks New Member

    Messages:
    3
    Likes Received:
    0
    Joined:
    Oct 1, 2008
    Hello everybody, i am new to this forum (as you could see from my post count), however. I've been looking for quite a while now for information regarding building heads and blocks for d-series.

    I am looking to set up a project for next summer (if i get my car running this summer and end up not selling it). and i would like to build a z6 to handle some good 400whp.

    The build needs to handle this amount, even tho, it doesn't mean that it will have this amount on it. Looking for information regarding step by step procedures on block and cylinder heads assembly. Torque numbers, tips that might be useful, things to look out for, etc.

    Any help would be really appreciated, thanks in advance.
     
  2. Matts96HB

    Matts96HB . Moderator VIP

    Messages:
    6,482
    Likes Received:
    389
    Joined:
    Apr 16, 2006
    Sounds like you belong here: Turbo D16 • Index page
    Start by doing your research there. Your questions can be easily answered with a little research. Good luck.
     
Verification:
Draft saved Draft deleted

Share This Page