1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Apexi Vafc b16a

Discussion in 'General Tech and Maintenance' started by dhondagini, Sep 5, 2003.

  1. dhondagini

    dhondagini Junior Member

    Messages:
    4
    Likes Received:
    0
    Joined:
    Sep 5, 2003
    I recently swapped a b16a into a 93 civic.
    I was planning on boosting it, but I didn't have time yet before school, so I am going to wait, but I still installed my VAFC anyway.

    I don't want to get it dyno'd without the boost because it will be a waste of money now.

    I was wondering if anyone has had it dyno'd with a similar setup as mine and can give me their settings so I can get close to where the settings should be.

    Here is my setup:
    b16a SIR2 hydro tranny p30 ecu
    ( I would assume that any civic SI or swapped b16 would be the same settings)
    Cam gears
    Fuel Regulator
    Exhaust
    wires
    Intake

    Its a basic setup, but if you have good numbers and your setup close, can you please let me know, it would definately be appreciated, thanks :worthy:
     
  2. B16

    B16 Super Moderator VIP

    Messages:
    11,539
    Likes Received:
    534
    Joined:
    Sep 30, 2002
    Location:
    yay area, CA
    i say leave it all at 0, stock. vtec x-over from lo->hi at 5300 and from hi -> lo at 5200
     
Verification:
Draft saved Draft deleted

Share This Page