1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

auto to manual ecu

Discussion in 'HYBRID -> ED-EF / DA' started by smashed4thgen, Aug 30, 2003.

  1. smashed4thgen

    smashed4thgen Senior Member

    Messages:
    140
    Likes Received:
    0
    Joined:
    Oct 2, 2002
    if i buy a automatic ecu for a 90 ls (its a p4)..how hard is it to conver to a manual..????
     
  2. CrxSiR

    CrxSiR Junior Member

    Messages:
    9
    Likes Received:
    0
    Joined:
    Sep 1, 2003
    Don't even think about it. Just search for the manual one. (PR4)
     
  3. smashed4thgen

    smashed4thgen Senior Member

    Messages:
    140
    Likes Received:
    0
    Joined:
    Oct 2, 2002
    ive found it once before...i know its a matter of soildering 2 resistors/jumpers...
    but i dont remember what ones...iam fairly sure it was on hondata's site
     
  4. nuc79

    nuc79 Senior Member

    Messages:
    164
    Likes Received:
    0
    Joined:
    Dec 4, 2002
    Location:
    SE Georgia (near Jacksonville, FL)

    Don't give mis-information. It's discouraging to the person asking the question. Fortunately, we can look at post counts and usually determine the credibility of the source(but not always):

    http://www.hondata.com/downloads/installat...on%20manual.doc

    Bottom of page 8. Same process as a PR3 ecu.
     
  5. civichbwithb18a1

    civichbwithb18a1 Member

    Messages:
    38
    Likes Received:
    0
    Joined:
    Sep 2, 2003
    its only a matter of removing a jumperwire and relocating it.
     
  6. CrxSiR

    CrxSiR Junior Member

    Messages:
    9
    Likes Received:
    0
    Joined:
    Sep 1, 2003
    Sorry, my bad. But I don't think it can be done unless u have to modify a little . If it can be done , then that's good. By the way, I don't mean to give out mis-info's. Because it had a reason to be auto and manual ECU.
     
  7. brian11to1

    brian11to1 Senior Member

    Messages:
    9,203
    Likes Received:
    21
    Joined:
    Jan 9, 2003
    Hey smashed4thgen I have an ECU for a 90-91 (obd-0) integra. IT's for a manual, I do need to get rid of it, so if you decide against removing and relocating let me know. Later man...
     
Verification:
Draft saved Draft deleted

Share This Page