1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Auto to manual swap

Discussion in 'HYBRID -> EG-EK / DC' started by dwn2low, Aug 25, 2004.

  1. dwn2low

    dwn2low Senior Member

    Messages:
    259
    Likes Received:
    0
    Joined:
    Jan 25, 2003
    Location:
    Little Rock AR
    Well I just got done swapping a b18b into my 93 HB and doing the auto to manual conversion wich was rather eazy thanks to HASPORTS new mount. However I have one question. How did you guys mount your linkage I tried to use the holes from the auto by troping screws through but it did not work please help.
     
  2. hcivic.com

    hcivic.com Senior Member

    Messages:
    4,571
    Likes Received:
    2
    Joined:
    Jan 7, 2003
    Location:
    Calgary Alberta canada
    it fit for with with a little bit of cuting and welding on the floor
     
  3. brian11to1

    brian11to1 Senior Member

    Messages:
    9,203
    Likes Received:
    21
    Joined:
    Jan 9, 2003
    I drilled new ones.
     
  4. dwn2low

    dwn2low Senior Member

    Messages:
    259
    Likes Received:
    0
    Joined:
    Jan 25, 2003
    Location:
    Little Rock AR
    Ok thanks guys for the replies I drilled new holes slightly further back then the existing holes.

    Now for some reason my main relay undeer my dash is buzzing. I tried to swap it out with another and it still buzzes. Did this happen to you? How do i fix this
     
Verification:
Draft saved Draft deleted

Share This Page