1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

b16 block/gsr pistons

Discussion in 'Engine Building' started by jtornado, Sep 22, 2007.

  1. jtornado

    jtornado New Member

    Messages:
    292
    Likes Received:
    3
    Joined:
    Oct 29, 2006
    Location:
    Minnesota
    what are the specs on this setup???
     
  2. jtornado

    jtornado New Member

    Messages:
    292
    Likes Received:
    3
    Joined:
    Oct 29, 2006
    Location:
    Minnesota
    nevermind I found specs myself. Forget thread. The compression will be very low
     
  3. plysndrt

    plysndrt New Member

    Messages:
    20
    Likes Received:
    0
    Joined:
    Feb 23, 2007
    mine ran 12.8 to 1 compression
     
  4. jtornado

    jtornado New Member

    Messages:
    292
    Likes Received:
    3
    Joined:
    Oct 29, 2006
    Location:
    Minnesota
    stock gsr pistons??????
     
  5. K2e2vin

    K2e2vin Senior Member

    Messages:
    8,446
    Likes Received:
    92
    Joined:
    Jan 2, 2003
    Location:
    Raleigh, NC
    I doubt it; B16 pistons have larger domes than GSR, and larger domes than USDM ITR's too(not sure about the JDM ITRs).
     
  6. jtornado

    jtornado New Member

    Messages:
    292
    Likes Received:
    3
    Joined:
    Oct 29, 2006
    Location:
    Minnesota
    well although the gsr rod length are longer than b16 so therefore that raises compression too.
     
  7. K2e2vin

    K2e2vin Senior Member

    Messages:
    8,446
    Likes Received:
    92
    Joined:
    Jan 2, 2003
    Location:
    Raleigh, NC
    Well, you're suppose to use correct rods. B16s have shorter block height than B18s.
     
Verification:
Draft saved Draft deleted

Share This Page