1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

b16 ek swap

Discussion in 'General Tech and Maintenance' started by ekdizaster, Jun 10, 2009.

  1. ekdizaster

    ekdizaster New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Jun 10, 2009
    Hey so im doing my first swap in my ek. i have a b16a and im using my stock single cam computer and harness. Has anyone done this?
     
  2. ekdizaster

    ekdizaster New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Jun 10, 2009
    so i have attempted to do the swap i had to swap the injector plugs from the jdm harness and the only thing left for me to do is to plug up the map and do the iacv fix. But i got a little anxious and tried to start the car but its not cranking over for me at all. not even the check engine light comes on when the car is on the key position. what did i do wrong?!!!!
     
  3. CAFROG

    CAFROG Honda Minion VIP

    Messages:
    4,417
    Likes Received:
    154
    Joined:
    Apr 5, 2009
    Location:
    NOR-CAL
    I think you need the obd2 p30 ecu or a chipped p28 (with conversion harness)

    B16 you got is obd2? Not sure but I think it makes things easier if you get a D16Y8 wire harness (but you can always run the wires too)
     
  4. CAFROG

    CAFROG Honda Minion VIP

    Messages:
    4,417
    Likes Received:
    154
    Joined:
    Apr 5, 2009
    Location:
    NOR-CAL
    WIRES.....VTEC/Knock Sensor wires
     
Verification:
Draft saved Draft deleted

Share This Page