1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

B16 head( type r internals ) onto jdm Gsr block

Discussion in 'Integra' started by Lupefromthelot, Sep 14, 2015.

  1. Lupefromthelot

    Lupefromthelot New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Sep 14, 2015
    Okay you guys. New to the forums. But Ima getting a b16a2 head with type r internals from a buddy off mine and Ima thinking about dealing it into my 94 Gsr block. I hear it fits and everything but. Taft the I take mainfold doesn't. And I was wondering if my dc2 ceramic header will fit into the b16 head? And what all would I have to do? Thanks you guys
     
  2. Briansol

    Briansol Admins Admin VIP

    Messages:
    21,455
    Likes Received:
    2,117
    Joined:
    Nov 18, 2007
    Location:
    CT
    the exhaust will fit, unless it's a special b16 one with low clearance on the oil pan as the b16 is physically shorter by a tick but the bolt pattern is the same. The intake won't work though, not right bolt pattern. just pick up a skunk2 or something for the b16.
     
  3. Lupefromthelot

    Lupefromthelot New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Sep 14, 2015
    that being said does that mean I can just put the head on? Or will I have to do the timing and all Taft good stuff again? Kinda have a low budget and I heard different things I had to do from different people.
     
  4. Briansol

    Briansol Admins Admin VIP

    Messages:
    21,455
    Likes Received:
    2,117
    Joined:
    Nov 18, 2007
    Location:
    CT
    pretty much... belt goes with the block/water pump gear. so you'll keep the gsr belt since the block and pump are gsr.

    you're going to want to tune it though. if you're running a p72 ecu (gsr) you're going to throw the IAB code, and the fueling will be a bit off due to different compression, camp profiles, etc.
     
Verification:
Draft saved Draft deleted

Share This Page