b16a in da issues

[kpowerd 4g4d]

i got a 2000 hybrid b16a swap in the da and i have a pr3 ecu and vtec pops at 4800 check engine light only comes on when i turn the car on but i have no codes. but my question is that it tacks out at 8000 and it doesnt have any o2 sensor and the car runs strong like that but when the o2s were in it ran like shit i have put 4 different brand new oe honda o2 in and the car runs the same i have both o2 sensors wired in and they are in the correct placement. any one have this problem. any help would be help full

 

[ls/vtechatch91]

plug them in and then reset the ecu... and mess with ignition timing.. and adjsut ur idling...

 

[kpowerd 4g4d]

i have had the battery unplugged for the weekend and have tried all that and no luck. could it be the ecu why is the car only taching out to 7900,8000 have an aftermarket tach installed to double check the engine rpms thanks

 

[ls/vtechatch91]

hmm... maybe ur tach is off.. pr3 i think tach out at 8200???

 

[kpowerd 4g4d]

stock tach is dead on with the aftermarket one