1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

B16a ring gap

Discussion in 'HYBRID -> ED-EF / DA' started by HATCHET_HONDA, Aug 20, 2008.

  1. HATCHET_HONDA

    HATCHET_HONDA scottie fizzle

    Messages:
    764
    Likes Received:
    10
    Joined:
    Mar 11, 2007
    Location:
    hobart, indiana
    a buddy of mine is rebuilding a b16 for his crx. hes not too mechanical so he took it to a machine shop to be redone. this shop mainly does chevys and such so i wasnt suprised when he said that they didnt check ring end gap clearances, he was told that since the block was rebored it wasnt goin to be an issue. wtf? will that motor be ok w/o this being checked?
     
  2. HATCHET_HONDA

    HATCHET_HONDA scottie fizzle

    Messages:
    764
    Likes Received:
    10
    Joined:
    Mar 11, 2007
    Location:
    hobart, indiana
    i believe they're NPR .5 oversize not factory honda rings
     
  3. HATCHET_HONDA

    HATCHET_HONDA scottie fizzle

    Messages:
    764
    Likes Received:
    10
    Joined:
    Mar 11, 2007
    Location:
    hobart, indiana
    what type of rings would have to be gapped?
     
  4. HATCHET_HONDA

    HATCHET_HONDA scottie fizzle

    Messages:
    764
    Likes Received:
    10
    Joined:
    Mar 11, 2007
    Location:
    hobart, indiana
    ahh i see... yea hes got npr rings with pr3 pistons...so the b16 should be good to go
     
Verification:
Draft saved Draft deleted

Share This Page