B16a swap wiring

We may earn a small commission from affiliate links and paid advertisements. Terms

2

2phatt

Member
I have a dx harness and I have added all the necessary wires for injection,
vtech, vtech oil, o2 sensor, distributor. ect.
I have all of my wiring layed out on the motor and I am missing a plug
The connector on the motor is brown plastic and it is on the side of the thermostat housing.
Could this be a fan signal?
I would have thought that this is a temp sensor but I already have a temp sensor plug wired in under the vtech that has a 2 pin plug with red w/ white and a green with white wire.
What color wires should feed this thermostat connector on my dx harness.
I have dx diagram but it is no help.
I have a photo if it will help


Thanks
Ralphs@comcast.net
 
I think I figured it out.

Thermoswitch off of the d15 at the back of the block.
The wires that feed it, I think should be connected to the BROWN plug in the thermostat of the b16a.
There is a black wire and a yellow w/green wire on the dx harness that did feed the thermoswitch.
New Question
Can I get them backward when I wire them in??????

Ralph Spencer
 
If a thermoswith just closes a circuit then I can't get them backwards or can I.

Is there anybody out there????????

Ralph
 
I hear ya, yeah the switch should be fine whichever way its wired its just a close open. I can check on my harness for colors if you like let me know if you still havent fixed.


-Justin
 
You must log in or register to reply here.
Back
Top