1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

b16a wiring issue

Discussion in 'HYBRID -> ED-EF / DA' started by Dark91zc, Jul 28, 2005.

  1. Dark91zc

    Dark91zc Senior Member

    Messages:
    283
    Likes Received:
    0
    Joined:
    Sep 9, 2004
    Location:
    Corona,CA
    ok i have swapped a b16a into a 90 crx and everything is wired up correctly hope fully but i go to start the car and the starter will not engage and the car ran prior to the swap. any ideas and does any one have the pinouts for the plugs on the driver and passanger side for the engine bay??
     
  2. racingtopher

    racingtopher Member

    Messages:
    91
    Likes Received:
    0
    Joined:
    Dec 23, 2003


    What do you mean by not engage?
    does the starter have a tapping sound? or any sound, what?

    I think I had a problem simmilar, try check the ground from the engine block to body.
     
  3. clanny

    clanny Member

    Messages:
    174
    Likes Received:
    0
    Joined:
    Oct 20, 2004
    Location:
    Scotland
    Check the ground on the starter!
     
  4. ko_si

    ko_si Junior Member

    Messages:
    9
    Likes Received:
    0
    Joined:
    May 27, 2005
    also check the ground thats on the thermostat houseing :)
     
Verification:
Draft saved Draft deleted

Share This Page