1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

B16B Vtec

Discussion in 'HYBRID -> EG-EK / DC' started by mr red, Apr 23, 2007.

  1. mr red

    mr red New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Apr 23, 2007
    Im currently swaping a B16b into a 2000 civic dx and the vtec sol dosent have an oil pressure switch like most B series vtec sol does anyone know how to wire the vtec if there isnt a oil pressure switch ???? i was thinkin i might have to jump some wires at the ecu so that it sees oil pressure so that the vtec will work has anyone had this problem before ???


    and what can i do to fix it thanks in advance
     
  2. xj0hnx

    xj0hnx I wanna be sedated VIP

    Messages:
    14,172
    Likes Received:
    48
    Joined:
    Nov 10, 2002
    Location:
    C.C.TX.
    It's been a while since I trolled through it, but I believe the wiring specifics for this are in teh reference section, check it out.
     
  3. TheManRSW

    TheManRSW TheManRSW

    Messages:
    387
    Likes Received:
    1
    Joined:
    Oct 18, 2006
    Location:
    Mooresville, NC
    I swapped a jdm b16 without the oil pressure switch. If the ecu isn't looking for it, then it isn't needed. The p30 ecu that came with the j-spec didn't need it and I have had no problems.
     
  4. mr red

    mr red New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Apr 23, 2007
    Thanks for the info ......I'll finish wiring it up and see if the ecu looks for it or not
     
Verification:
Draft saved Draft deleted

Share This Page