1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

B18c1 Cams

Discussion in 'Engine Building' started by Viperlocc_B18C1, Mar 4, 2003.

  1. Viperlocc_B18C1

    Viperlocc_B18C1 Senior Member

    Messages:
    115
    Likes Received:
    0
    Joined:
    Mar 3, 2003
    Location:
    Madison, WI
    Should i just upgrade the intake side using the Type-R cams or should i just do the whole shibang (both intake and exhaust) using spoon or mugen? any other choices that are of good quality?
     
  2. asmallsol

    asmallsol Super Moderator

    Messages:
    8,074
    Likes Received:
    3
    Joined:
    Sep 28, 2002
    Location:
    Houghton/Livonia Michigan
    I would do the whole thing. If you have the money, consider getting the Skunk 2 Stage 2 cams with springs, retainers, and valves. This one keeps a stock idle but i have seen a few dyno charts say these give up to 12 hp over the ITR setup.
     
  3. civism

    civism Banned

    Messages:
    14
    Likes Received:
    0
    Joined:
    Feb 26, 2003
    i go with TODA
     
  4. ekPhred

    ekPhred Senior Member

    Messages:
    437
    Likes Received:
    0
    Joined:
    Nov 11, 2002
    i agree with sol, it ultimately depends on how much money you're actually willing to spend. if you have the dough, i would suggest spoon or toda. if you dont really have that much money, i would suggest going the itr/ctr combo, if not get the skunks stage 2, also upgrade to valve springs and retainers while you're at it. good luck.
     
Verification:
Draft saved Draft deleted

Share This Page