1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

b20 hesitates at take off then picks up

Discussion in 'General Tech and Maintenance' started by 94tegga, May 1, 2015.

  1. 94tegga

    94tegga New Member

    Messages:
    6
    Likes Received:
    0
    Joined:
    Feb 3, 2015
    Other day at the strip I was testing the b20 swap it drove just fine to the strip. After the 3 run and driving back the engine had no power at take off then it would "kick" in after reving it kinda high and go then after shifting it would do the same thing. I was thinking maybe a spun bearing or bad rings maybe I dont have my compression checker here I just got stationed in EL Paso and Im waiting on my tools to arrive fro TN. Any input or suggestions would be great. Thank you
     
  2. CAFROG

    CAFROG Honda Minion VIP

    Messages:
    4,416
    Likes Received:
    153
    Joined:
    Apr 5, 2009
    Location:
    NOR-CAL
    I don't know why but my first thought was clutch assembly.
     
  3. 94tegga

    94tegga New Member

    Messages:
    6
    Likes Received:
    0
    Joined:
    Feb 3, 2015
    See I was thinking that as well but it just seemed odd it would kick in like it does
     
  4. CAFROG

    CAFROG Honda Minion VIP

    Messages:
    4,416
    Likes Received:
    153
    Joined:
    Apr 5, 2009
    Location:
    NOR-CAL
    Car revs fine when in neutral?
     
  5. 94tegga

    94tegga New Member

    Messages:
    6
    Likes Received:
    0
    Joined:
    Feb 3, 2015
    No the car would hesitate in N as well. I was thinking about it and dug into it yesterday pulled the cat and it had wire and everything else showing that it had blown out. Pulled the cat off now to get it running I think the dizzy went out lol
     
Verification:
Draft saved Draft deleted

Share This Page