1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Boost ready b18c longblock f/s

Discussion in 'Parts: For Sale/Trade/Wanted' started by b16ahybrid, Apr 29, 2006.

  1. b16ahybrid

    b16ahybrid Junior Member

    Messages:
    14
    Likes Received:
    0
    Joined:
    Dec 28, 2005
    The block is fully built and ready for boost.
    Golden eagle Sleeves (81.5mm bore)
    Wiseco coated pistons (9.5:1)
    Eagle rods.
    The block was professionally asseblembled using ACL bearings ... Stock b18c head bolted to the block with Golden Eagle head studs and a factory acura head gasket, torqued down per G/E spec.
    Brand new water pump and timing belt.
    Comes with a Skunk2 intake manifold, dist,sensors,and MSD 6-AL ignition (wired into the wiring harness for a clean install)..
    Parts alone have cost me about $2,400 without labor...(block alone)
    Asking $2,400 for the complete long block...
    Make me an offer within reason, I DONT have to sell, but would LIKE to sell the engine....
    Thanks for taking your time to look.

    Oh the motor has -0- miles on it, it's been fired up, ran for a few and then shut down....

    Prior to head install
    http://i78.photobucket.com/albums/j103/b16...engineblock.jpg

    during head install
    http://i78.photobucket.com/albums/j103/b16...id/100_0401.jpg
    Can provide more pics upon request...

    Located in Washington state.
     
  2. driver1

    driver1 Senior Member

    Messages:
    1,979
    Likes Received:
    0
    Joined:
    Jan 15, 2003
    ur pics are junk....they dont work
     
  3. HatchSpeeD

    HatchSpeeD ...Hi...

    Messages:
    1,241
    Likes Received:
    0
    Joined:
    Apr 14, 2003
    Location:
    Beantown
    Third times a charm
     
  4. pageusaf

    pageusaf Senior Member

    Messages:
    198
    Likes Received:
    0
    Joined:
    Apr 16, 2006
    Location:
    Pittsburgh, PA
    use imageshack

    www.imageshack.us

    never had a pic do that stupid photobucket shit
     
  5. b16ahybrid

    b16ahybrid Junior Member

    Messages:
    14
    Likes Received:
    0
    Joined:
    Dec 28, 2005
    Thanks for the bumps, I couldn't get in yesterday to fix them. They now work.
     
  6. b16ahybrid

    b16ahybrid Junior Member

    Messages:
    14
    Likes Received:
    0
    Joined:
    Dec 28, 2005
    Bump....
    The motor is out of the car and ready for pick-up or drlivery...
     
  7. b16ahybrid

    b16ahybrid Junior Member

    Messages:
    14
    Likes Received:
    0
    Joined:
    Dec 28, 2005
Verification:
Draft saved Draft deleted

Share This Page