1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cam gear install

Discussion in 'General Tech and Maintenance' started by rudeludenotmeanthough, Sep 28, 2003.

  1. rudeludenotmeanthough

    rudeludenotmeanthough Senior Member

    Messages:
    1,406
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    What should i adjust my cam gear too? They are AEM. I searched their site and found nothing. So what do you guys reccomend. The motor is b20a.

    Thanks
     
  2. SleEPeR_CRX

    SleEPeR_CRX Senior Member

    Messages:
    1,226
    Likes Received:
    0
    Joined:
    Dec 22, 2002
    Location:
    Vancouver B.C. canada
    3 degrees intake
    1 degree exhaust

    go from there
     
  3. rudeludenotmeanthough

    rudeludenotmeanthough Senior Member

    Messages:
    1,406
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    advance intake, and retard exaust? Also, is there a tesioner that i need to lock. If so where is it?
     
  4. pills_PMD

    pills_PMD Super Moderator

    Messages:
    4,232
    Likes Received:
    0
    Joined:
    Sep 30, 2002
    Location:
    New Albany, OH
    i wouldn't go more than +2 intake -2 exhaust at first. you are going to have to play around with it to feel whats best on your particular engine. try 1,0 first then +1,-1 and switch em around a little bit and drive on them for a day or so to see where its pulling hard etc.

    the tensioner is easy to see. it's round smaller than a cam gear and the timing belt runs along it
     
Verification:
Draft saved Draft deleted

Share This Page