1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Car bogging

Discussion in 'General Tech and Maintenance' started by VTECPOWER, Oct 17, 2005.

  1. VTECPOWER

    VTECPOWER Senior Member

    Messages:
    1,683
    Likes Received:
    0
    Joined:
    Oct 6, 2003
    Location:
    Winchester, VA
    Just put in the pr3, had the pw0 in my crx b16, now it bogs until i floor it, so i switch the pin-outs on the ecu for the o2 sensors, correct? They are c8 and c16? I cant remember off the top of my head, i have the paper out in the garage and am too lazy to go look, but i will switch the pin-outs tomarrow.
     
  2. B16CRX

    B16CRX Senior Member

    Messages:
    531
    Likes Received:
    0
    Joined:
    Jan 24, 2004
    Location:
    Greenville, SC
    yea that's it, but it wont matter if you dont have both o2 sensors wired up. MAke sure you have both installed and wired first.
     
  3. VTECPOWER

    VTECPOWER Senior Member

    Messages:
    1,683
    Likes Received:
    0
    Joined:
    Oct 6, 2003
    Location:
    Winchester, VA
    I do, no cel's now, ill check the wiring again, but ill just re-pin those 2.
     
Verification:
Draft saved Draft deleted

Share This Page