Changing axle end for swap, hard?

[92CHB]

I just ordered a jdm dohc ZC swap for my eg hatch and i have to make custom axles to make it work. The inputs on the transmission and half shaft are different than a usdm tranny so i have to put jdm zc inner axle ends(can purchase through ebay) on usdm axles. I have been reading through my chilton manual and it doesnt seem to be that discriptive on the inner cv joints removal/installation. All i need to do is change the inner cv joint, is this hard to do?

 

[phyregod]

Easy stuff. Hardest part will be getting the old one off. Just be rough with it, that lil snap-ring will give up sooner or later. After that, its a breeze.

 

[92CHB]

Sweet thank you!

 

[phyregod]

You'll also want to change those inner boots while you are there. Its no extra work and the boots are usually only around $10-15 each and come with the clamps and grease.. Which you are going to need anyway.

 

[92CHB]

okay i'll look into that