1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

CLUTCH STUCK

Discussion in 'General Tech and Maintenance' started by racintweek, Mar 19, 2004.

  1. racintweek

    racintweek Senior Member

    Messages:
    743
    Likes Received:
    0
    Joined:
    Mar 13, 2004
    Location:
    Arlington VA
    92 LS

    i recently installed an exedy clutch and lightened flywheel

    i used to be able to pull up on the fork where the cable attaches about 4.5"

    now with new stuff installed when i pull on the fork i hear the release bearing hit the press plate and then it wont budge

    is this normal due to the stiffer press plate or did i do something wrong?

    :wtf:
     
  2. racintweek

    racintweek Senior Member

    Messages:
    743
    Likes Received:
    0
    Joined:
    Mar 13, 2004
    Location:
    Arlington VA
    help
     
  3. racintweek

    racintweek Senior Member

    Messages:
    743
    Likes Received:
    0
    Joined:
    Mar 13, 2004
    Location:
    Arlington VA
    :blah: stop reading about the container and help me :blah:
     
  4. JDMilan

    JDMilan Senior Member

    Messages:
    6,730
    Likes Received:
    0
    Joined:
    May 11, 2003
    Location:
    Boca Raton, FL
    sounds like you did something wrong,,,,,,try to tighten the adjustment screw on the calbe itself.
     
  5. slammedb18acivic

    slammedb18acivic Senior Member

    Messages:
    286
    Likes Received:
    0
    Joined:
    Dec 16, 2002
    Location:
    pa
    you could of put the spring on wrong for the release bearing. Mine actually broke off inside once! that sucked. .
     
  6. civic_types

    civic_types Senior Member

    Messages:
    139
    Likes Received:
    0
    Joined:
    Jan 28, 2004
    to be honest it simply doesn't seemed properly aligned.
     
  7. racintweek

    racintweek Senior Member

    Messages:
    743
    Likes Received:
    0
    Joined:
    Mar 13, 2004
    Location:
    Arlington VA
    the motor and trans are out od the car

    should i just take it apart and try it again?
     
  8. arpee79

    arpee79 Senior Member

    Messages:
    362
    Likes Received:
    0
    Joined:
    Aug 9, 2003
    YUP and get a helm or a service manual for your car that really help alot.
     
Verification:
Draft saved Draft deleted

Share This Page