code 23

[silverb16teg]

i have a 90 integra and i just installed a b16a engine. everything works fine but i get a code 23-which i think is the knock sensor. i also have a pr3 ecu. what can i do to get rid of the code?

 

[radnulb]

wire in the knock sensor?

if you're convinced the wiring is 100% correct:
-replace the KS
-chip the ECU with a program that doesn't look for knock

 

[silverb16teg]

i have the knock sensor wired to ecu pinout b19. not sure if wiring is ok though. used knock sensor that came wit used b16, and also the one from the original motor.

 

[tab]

I grabbed harness ends from the junk yard, and pulled out some of the pins with the color or wire I wanted. Solder each end of the wire and pop your new pin in the right slot. Presto, like it was always there.